6ES7 972-0CB20-0XA0 connect with Siemens S7-200/300 PLC

The 6ES7972-0CB20-0XA0 cable is used for siemens plc s7-200 s7-300/400 plc Communication. Some touch screens also can use this cable.

How the connect with Siemens S7-200 PLC

  • Found driver
  • Open S7-200 programming software
  • Select S7-200 communication protocol, set PG/PC Interface
  • Choose PC Adapter(PPI)
  • Setting baud rate property option
  • ChoosePLC baud rate
s7-200 ppi protocol communication

How connect with Siemens S7-300 PLC?

  • Found Driver
  • Choose DP protocol communication
  • Choose PLC baud rate
  • Setting all the parameters and protocol then will start communication
s7-300 dp protocol communication setting

11 thoughts on “6ES7 972-0CB20-0XA0 connect with Siemens S7-200/300 PLC”

  1. Hi everyone can we use this Adapter 6ES7 972-0CB20-0XA0 for S7 -200 S7-300 S7- 400 NOTE i have windows 10 professional 64 bit,
    Or can you recommend me any kind of adapter for S7 -200 S7-300 S7- 400 but support windows 10 professional l?
    Greetings
    Ahmer

    Reply
  2. I was unable to connect to profibus even with the driver from your site. MPI works fine but no nodes detected on DP, could a firmware update fix this?

    Reply
    • The use of cable depends on the driver. The 0ba00 driver is installed together with the software installation. If you have successfully installed the programming software on windows 11,data cable can be used

      Reply
  3. hello everyone i have 6ES7 972-0CB20-0XA0 cable amsomation when i can communicate with s7-200 windows 10 64 bit
    A CPU 226 automaton accepted normal communications but another automaton with the same reference cannot communicate where is the problem !!

    Reply

Leave a Comment