GT01-C30R2-6P Suitable Mitsubishi GT11/GT15 Series HMI Touch Panel Connect Mitsubishi Q Series PLC Programming Cable


Interface: DB9Pin-MD6Pin Male
Cable Length: 2.5m
Purpose: Suitable Mitsubishi GT11/15 Touch panel HMI Connect Mitsubishi Q Series PLC Programming cable

To connect a Mitsubishi GT01-C30R2-6P HMI (human-machine interface) touch panel to a Mitsubishi Q Series PLC (programmable logic controller), you will need to use a programming cable. This cable will typically have a connector on one end that plugs into the HMI, and a connector on the other end that plugs into the PLC. The type of connector required will depend on the specific models of the HMI and PLC that you are using.

Once the programming cable is connected, you will need to configure the HMI and PLC to communicate with each other. This can typically be done through the HMI’s configuration software, or through the PLC’s programming software. You may need to enter the PLC’s communication settings, such as its IP address and communication protocol, into the HMI in order to establish a connection.

Once the HMI and PLC are connected and configured, you can use the HMI to monitor and control the operation of the PLC and any connected devices.

Additional information






There are no reviews yet.

Be the first to review “GT01-C30R2-6P”

Worldwide Free Shipping is guaranteed to global online consumers in AMSAMOTION.STORE. We guarantee total shopping satisfaction by offering exchange, Return or Refund Policy.